Datasheet Linear Technology LTC3245EDE#PBF — 数据表

数据表

打包

参数化

生态计划

文章

• 下载
  2.7V to 38V VIN Range, Low Noise, 250mA Buck-Boost Charge Pump Converter &mdash LT Journal
  PDF, 230 Kb, 档案已发布: Jan 6, 2014
  从文件中提取

  design features 2.7V to 38V VIN Range, Low Noise, 250mA Buck-Boost
  Charge Pump Converter
  George H. Barbehenn The LTC3245 is a buck-boost regulator that dispenses with the traditional inductor,
  and instead uses a capacitor charge pump. The LTC3245’s input voltage range is
  2.7V to 38V, and it can be used without a feedback divider to produce one of two
  fixed output voltages, 3.3V and 5V, or programmed via a feedback divider to any
  output voltage from 2.5V to 5.5V. Maximum output current is 250mA. As a result of
  its buck-boost topology, the LTC3245 is capable of regulating a voltage above or
  below the input voltage, allowing it to satisfy automobile cold crank requirements.
  The LTC3245 achieves efficiency of
  80% when delivering 5V, 100m A from
  a 12V source, significantly higher efficiency than an LDO, making it possible
  to avoid the space and cost requirements of an LDO with a heat sink. The
  LTC3245 is available in an exposed
  pad MSOP12 or 3mm Г— 4mm DFN12. Because N and M are integers, a straight
  charge pump cannot be used to produce an arbitrary output. Instead the
  controller modifies VIN to produce VIN′,
  which is then fed to the charge pump.
  The charge pump can operate in one of
  three modes, buck, LDO or boost, resulting in ½VIN′, VIN′ or 2VIN′, respectively. CHARGE PUMP OPERATION By properly controlling both VIN′ and
  the operating mode of the charge pump
  any arbitrary voltage can be achieved.
  When operating in buck mode, the …

模型线

制造商分类

• Power Management > Inductorless (Charge Pump) DC/DC Converters > High Voltage Charge Pumps | Regulated Buck-Boost Charge Pumps
• Space & Harsh Environment > Extended Temperature Plastic (H & MP) > Extended Temperature (H & MP) Power Management

其他名称:

LTC3245EDEPBF, LTC3245EDE PBF