Datasheet Analog Devices ADIS16480AMLZ — 数据表

Ten Degrees of Freedom Inertial Sensor
with Dynamic Orientation Outputs
ADIS16480 Data Sheet
FEATURES GENERAL DESCRIPTION Dynamic angle outputs
Quaternion, Euler, rotation matrix
0.1° (pitch, roll) and 0.3° (yaw) static accuracy
Triaxial, digital gyroscope, ±450°/sec dynamic range
±0.05° orthogonal alignment error
6°/hr in-run bias stability
0.3°/√hr angular random walk
0.01% nonlinearity
Triaxial, digital accelerometer, ±10 g
Triaxial, delta angle and delta velocity outputs
Triaxial, digital magnetometer, ±2.5 gauss
Digital pressure sensor, 300 mbar to 1100 mbar
Adaptive extended Kalman filter
Automatic covariance computation
Programmable reference reorientation
Programmable sensor disturbance levels
Configurable event-driven controls
Factory-calibrated sensitivity, bias, and axial alignment
Calibration temperature range: −40°C to +85°C
SPI-compatible serial interface …

Silicon Anomaly Ten Degrees of Freedom MEMS Inertial
Sensor with Dynamic Orientation Outputs
ADIS16480 This anomaly list describes the known bugs, anomalies, and workarounds for the ADIS16480.
Analog Devices, Inc., is committed, through future silicon revisions, to continuously improve silicon functionality. Analog Devices tries
to ensure that these future silicon revisions remain compatible with your present software/systems by implementing the recommended
workarounds outlined here. FUNCTIONALITY ISSUES
Table 1. Incorrect Scale Factors for the x_DELTANG_OUT Registers and the x_DELTANG_LOW Registers [er001]
Background Issue
Workaround
Related Issues The ADIS16480 provides delta angle registers, which contain sample-to-sample angle displacement estimates for all three
axes. The x_DELTANG_OUT registers provide the upper 16 bits, and the x_DELTANG_LOW registers provide the lower 16 bits.
The x_DELTANG_OUT registers typically provide a scale factor of 720 ÷ 215 degrees per LSB, and the x_DELTANG_LOW
registers provide additional resolution (720 ÷ 231 degrees per LSB).
On units that have Firmware Revision 2.01 (or earlier), the delta angle registers do not have the same scale factors as those
listed in the ADIS16480 data sheet. For these units, the scale factors are 274 ÷ 215 degrees per LSB for x_DELTANG_OUT and
274 ÷ 231 degrees per LSB for x_DELTANG_LOW.
Use 274 ÷ 215 degrees per LSB for the x_DELTANG_OUT scale factor and 274 ÷ 231 degrees per LSB for the x_DELTANG_LOW
scale factor. Use the FIRM_REV register to determine the firmware revision of a unit. For example, FIRM_REV = 0x0201
equates to a Firmware Revision 2.01.
None. Table 2. Incorrect Scale Factors for the x_DELTVEL_OUT Registers and the x_DELTVEL_LOW Registers [er002]
Background Issue
Workaround
Related Issues The ADIS16480 provides delta velocity registers, which contain sample-to-sample velocity estimates for all three axes. The …