Power over Ethernet Isolated Power Supply
Delivers 11.5W at 90% Efficiency – Design Note 338
Jesus Rosales
fewer switches to turn on and off the better. A push-pull
converter could be used, but the additional complexity
is not justified at this power level. A single transistor
forward converter is another option, but requires
an additional output inductor and rectifier. A flyback
converter is the simplest choice. Flyback converters
are thought to be less efficient than forward and pushpull converters, but that changes when the output is
synchronously rectified (a MOSFET is used instead of
a diode to rectify the output). When powering IP telephones, wireless access points,
PDA charging stations and other PDs (Powered Devices)
from an Ethernet cable, designers have at most 12.95W
of available power per the IEEE 802.3af standard. Increased demands for power mandate a very efficient
power converter especially for classВ 3 devices (consuming between 6.49W and 12.95W). The more power lost
in the converter, the less power available for the PD.
The voltage available from the PSE (Power Sourcing
Equipment) ranges from 44V to 57V, but PDs need to
operate with as much as 20О© of series wire resistance.
A PD can never draw more than 350mA or 12.95W
continuously. With the maximum input current of
350mARMS, the input voltage can droop as much as …