Datasheet Linear Technology LT1513-2IR#TRPBF — 数据表

数据表

价格

打包

参数化

生态计划

其他选择

LT1513 LT1513

应用须知

• 下载
  Linear Technology Magazine Circuit Collection, Volume IV &mdash AN84
  PDF, 2.4 Mb, 档案已发布: Apr 1, 2000
  Application Note 84 is a collection of "power circuits" from the years 1996 through 1998 as seen in the pages of Linear Technology magazine. This Application Note collects circuits that can output tens of amps to circuits that can operate a handheld device for several years. In addition to a wide variety of traditional power supply circuits (Buck, Boost, Inverting, Flyback, Linear Regulators, etc.) we include circuits for charging batteries, several Power Management circuits as well as circuits that highlight a very low noise switching regulator.
  从文件中提取

  Application Note 84
  April 2000 Linear Technology Magazine Circuit Collection, Volume IV
  Power Products
  Richard Markell, Editor
  INTRODUCTION
  Application Note 84 is the fourth in a series that excerpts
  useful circuits from Linear Technology magazine to preserve them for posterity. This application note highlights
  “power” circuits from issue VI:1 (February 1996) through
  issue VIII:4 (November 1998). Another application note
  will feature data conversion, interface and signal processing circuits from the same era. Like its predecessor, AN 66,
  this Application Note includes circuits that can power
  most any system you can imagine, from “server” power
  supplies that generate in excess of 50 amps to micropower systems for portable and handheld equipment.
  Also included are power converters that can be voltage programmed using Intel’s VID code. Charge pump converters, linear regulators and battery charger circuits are
  included here, with Li-Ion batteries receiving extra attention. There are, of course, circuits that cannot be so simply
  categorized. Come browse. I’ll get out of the way and let
  the authors describe their creations.
  Note: Article Titles appear in this application note exactly
  as they originally appeared in Linear Technology magazine. This may result in some inconsistency in the usage
  of terminology. TABLE OF CONTENTS
  Introduction . 1
  REGULATORS—SWITCHING (BUCK)
  New LTCВ®1435–LTC1439 DC/DC Controllers Feature Value and Performance . 4 …

设计须知

• 下载
  Low Input Voltage CCFL Power Supply &mdash DN133
  PDF, 75 Kb, 档案已发布: Jul 2, 1996
  从文件中提取

  Low Input Voltage CCFL Power Supply – Design Note 133
  Fran Hoffart
  Cold cathode fluorescent lamps (CCFLs) are often
  used to illuminate liquid crystal displays (LCDs). These
  displays appear in laptop computers, gas pumps, automobiles, test equipment, medical equipment and the
  like. The lamps themselves are small, relatively efficient
  and inexpensive, but they must be driven by specialized power supplies. High AC voltage (significantly
  higher than the operating voltage) is needed to start
  the lamp. A sinusoidal waveform is desired, the current
  must be regulated, efficiency should be high and the
  power supply must be self-protecting in the event of
  an open-lamp condition.
  CCFL power supplies consisting of a Royer class, selfoscillating sine wave converter driven by an LTВ®1513
  switching regulator are shown in Figures 1 and 2. These
  circuits are especially suited for low voltage operation,
  with guaranteed operation for input voltages as low as
  2.7V and as high as 20V. High voltage output regulated
  Royer converters, although capable of 90% efficiency,
  are not well-suited for low input voltage operation and
  C1
  2.7V
  47ОјF TO 20V
  L1 …

• 下载
  Li-Ion Charge Termination IC Interfaces with PWM Switchers &mdash DN242
  PDF, 74 Kb, 档案已发布: Oct 2, 2001
  从文件中提取

  Li-Ion Charge Termination IC Interfaces with PWM Switchers
  Design Note 242
  Fran Hoffart
  Rechargeable lithium-ion batteries are rapidly becoming the battery of choice for many battery-powered
  products. These products include notebook computers, PDAs, video camcorders, digital cameras, cellular
  phones, portable test equipment and others. Compared
  to other rechargeable power sources, Li-Ion batteries
  have higher energy density for both weight and volume
  and provide longer run time between charges. tery from overtemperature and overcurrent conditions.
  In addition, battery packs may also contain back-toback MOSFET switches that disconnect the battery if
  an overcurrent condition exists for either charge or
  discharge, or if an overvoltage or undervoltage condition exists. Many of these precautions are needed
  because lithium-ion cells are easily damaged by both
  overcharge and overdischarge conditions. Charging Li-Ion batteries is a relatively simple process.
  Apply a current-limited (at a 1C rate) constant voltage
  (В±1% tolerance) for approximately three hours, then
  stop charging. (C is a battery term used to indicate
  the Ampere-hour capacity of a battery). A complete
  charge cycle may also include precharge qualification
  for battery temperature and precharge qualification for
  deeply discharged batteries. LTВ®1510 Battery Charger IC
  The LT1510 is a high efficiency switching regulator
  power IC designed speciп¬Ѓcally for battery charging …

模型线

制造商分类

• Power Management > Battery Management > Battery Charger IC > Switching Battery Chargers | Buck/Boost Battery Chargers

其他名称:

LT1513-2IRTRPBF, LT1513-2IR TRPBF, LT15132IR#TRPBF, LT1513 2IR#TRPBF