Datasheet Linear Technology LT1024 — 数据表

制造商	Linear Technology
系列	LT1024

双通道、匹配的微微安、微伏输入、低噪声运算放大器

数据表

预览并下载

PDF, 179 Kb, 语言: en, 文件上传: Aug 4, 2017, 页数: 12
Dual, Matched Picoampere, Microvolt Input, Low Noise Op Amp

从文件中提取

价格

打包

	LT1024ACN#PBF	LT1024CN#PBF
N	1	2
Package	N-14 包装外形图	N-14 包装外形图
Package Code	N	N
Package Index	05-08-1510 (N14)	05-08-1510 (N14)
Pin Count	14	14

参数化

Parameters / Models	LT1024ACN#PBF	LT1024CN#PBF
Av Min Stable, V/V	1	1
Avol, dB	66	66
Common Mode Rejection Ratio, dB	132	132
Number of Channels	2	2
Cload, pF	1000	1000
Design Tools	LTspice Model	LTspice Model
Enoise 1/f Corner, Hz	2.5	2.5
Enoise Density, nV/rtHz	14	14
Export Control	no	no
GBW, MHz	1	1
Ibias, nA	0.025	0.025
Inoise, pA/rtHz	0.02	0.02
Inoise 1/f Corner, Hz	140	140
Ios, µA	0.00002	0.00002
Iout, mA	10	10
Isupply, mA	0.38	0.38
LF Enoise, µVPP	0.5	0.5
Operating Temperature Range, °C	0 to 70	0 to 70
Over-the-Top	no	no
PSRR, dB	132	132
Rail-to-Rail In	no	no
Rail-to-Rail Out	no	no
SR, V/µs	0.2	0.2
Shutdown	no	no
Single Supply	no	no
Type	VFB	VFB
Voh (from V+), V	1	1
Vol (from V-), V	1	1
Vos, mV	0.015	0.015
Vos TC, µV/C	0.25	0.25
Vs Max, V	40	40
Vs Min, V	4	4

生态计划

	LT1024ACN#PBF	LT1024CN#PBF
RoHS	Compliant	Compliant

设计须知

下载
Temperature Measurement Using Data Acquisition Systems &mdash DN5
PDF, 77 Kb, 档案已发布: Mar 1, 1989
从文件中提取
Temperature Measurement Using Data Acquisition Systems
Design Note 5
William Rempfer and Guy Hoover
Introduction
Accurate temperature measurement is a difп¬Ѓcult and
very common problem. Whether recording a temperature, regulating a temperature or modifying a process
to accommodate a temperature, the LTCВ®1090 family
of data acquisition systems can provide an important
link in the chain between the blast furnace temperature
and the microcontroller. Features of the LTC1090 family
can make temperature measurement easier, cheaper
and more accurate.
High DC input resistance and reduced span operation
allow direct connection to many standard temperature
sensors. Multiplexer options allow one chip to measure
up to 8 channels of temperature information. Single
supply operation, modest power requirements (~5mW)
and serial interfaces make remote location possible.
Switching power on and off lowers power consumption (560ОјW) even more for battery applications.
Finally, because few sensors have accuracies as good as 0.1%, the 10-bit resolution and 0.05% accuracy of
the LTC1090 family are just right for most temperature
sensing applications.
Thermocouple Systems …
下载
3V Operation of Linear Technology Op Amps &mdash DN56
PDF, 78 Kb, 档案已发布: Feb 1, 1992
从文件中提取
3V Operation of Linear Technology Op Amps -Design Note 56
George Erdi
The latest trend in digital electronics is the introduction
of numerous ICs operating on regulated 3V or 3.3V
power supplies. This is a logical development to increase
circuit densities and to reduce power dissipation. In addition, many systems are directly powered by two AA
cells or 3V lithium batteries. Clearly, analog ICs which
work on 3V with good dynamic range to complement
these digital circuits are, and will be, in great demand.
Many Linear Technology operational ampliп¬Ѓers work
well on a 3V supply. The purpose of this design note
is to list these devices and their performance when
powered by 3V. The op amps can be divided into two
groups: single and dual supply devices. The single supply
op amps are optimized for, and fully speciп¬Ѓed at, a 5V
positive supply with the negative supply terminal tied
to ground. Input common mode voltage range goes
below ground, and the output swings to within a few
millivolts of ground while sinking current. Members of
the single supply family are the micropower LTВ®1077/
LT1078/LT1079 single, dual and quad op amps with
40ОјA supply current per ampliп¬Ѓer, the LT1178/LT1179 dual and quad with 13ОјA per ampliп¬Ѓer. The LT1006/
LT1013/LT1014 single, dual and quad have faster speed …

模型线

系列: LT1024 (2)

LT1024ACN#PBF LT1024CN#PBF

制造商分类

Signal Conditioning > Amplifiers > Operational Amplifiers (Op Amps) > Precision Amplifiers (Vos | High Voltage Amplifiers (>12V) | Low Power Amplifiers (Is < 1mA/amp) | Low Bias Current Amplifiers (Ib < 100pA)