Datasheet Texas Instruments THS6042IDDA — 数据表

制造商Texas Instruments
系列THS6042
零件号THS6042IDDA
Datasheet Texas Instruments THS6042IDDA

350mA,+ /-12V ADSL CPE线路驱动器8-SO PowerPAD -40至85

数据表

350 mA +/-12V ADSL CPE Line Drivers datasheet
PDF, 1.6 Mb, 修订版: G, 档案已发布: Dec 11, 2001
从文件中提取

价格

状态

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityNo

打包

Pin8
Package TypeDDA
Industry STD TermHSOIC
JEDEC CodeR-PDSO-G
Package QTY75
CarrierTUBE
Device Marking6042I
Width (mm)3.9
Length (mm)4.89
Thickness (mm)1.48
Pitch (mm)1.27
Max Height (mm)1.7
Mechanical Data下载

参数化

2nd Harmonic67 dBc
3rd Harmonic96 dBc
@ MHz1
Acl, min spec gain1 V/V
Additional FeaturesN/A
ArchitectureCurrent FB
BW @ Acl120 MHz
CMRR(Min)59 dB
CMRR(Typ)68 dB
GBW(Typ)120 MHz
Input Bias Current(Max)10000000 pA
Iq per channel(Max)10.5 mA
Iq per channel(Typ)8.2 mA
Number of Channels2
Offset Drift(Typ)20 uV/C
Operating Temperature Range-40 to 85,0 to 70 C
Output Current(Typ)350 mA
Package GroupSO PowerPAD
Package Size: mm2:W x L8SO PowerPAD: 29 mm2: 6 x 4.9(SO PowerPAD) PKG
Rail-to-RailNo
RatingCatalog
Slew Rate(Typ)1400 V/us
Total Supply Voltage(Max)33 +5V=5, +/-5V=10
Total Supply Voltage(Min)9 +5V=5, +/-5V=10
Vn at 1kHz(Typ)2.4 nV/rtHz
Vn at Flatband(Typ)2.2 nV/rtHz
Vos (Offset Voltage @ 25C)(Max)16 mV

生态计划

RoHSCompliant

设计套件和评估模块

  • Evaluation Modules & Boards: THS6042EVM
    THS6042 Evaluation Module
    Lifecycle Status: Active (Recommended for new designs)

应用须知

  • Active Output Impedance for ADSL Line Drivers
    PDF, 636 Kb, 档案已发布: Nov 26, 2002
    Signal termination is very common in bidirectional communication systems. Termination allows for receiving signals while transmitting different signals at the same time. With the increasing popularity of asymmetrical digital subscriber lines (ADSL), the requirement for a low power line driver amplifier combined with line termination becomes a very difficult goal. This application note examines the
  • Noise Analysis for High Speed Op Amps (Rev. A)
    PDF, 256 Kb, 修订版: A, 档案已发布: Jan 17, 2005
    As system bandwidths have increased an accurate estimate of the noise contribution for each element in the signal channel has become increasingly important. Many designers are not however particularly comfortable with the calculations required to predict the total noise for an op amp or in the conversions between the different descriptions of noise. Considerable inconsistency between manufactu

模型线

制造商分类

  • Semiconductors > Amplifiers > Operational Amplifiers (Op Amps) > High-Speed Op Amps (>=50MHz)